AccuQuilt GO! Sparkle-Tree by Sarah Vedeler Die
AQ Cutting Mat Required: GO! Cutting Mat, 10 in. x 10 in. 2 Pack (25.4 cm x 25.4 cm) Item 55203
Cut Size: Diamond: 10 1/4"W x 4 1/4"H (26 cm x 10.8 cm), Large Tree Leaf: 5 3/4"W x 4 1/2"H (14.6 cm x 11.4 cm), Small Tree Leaf: 3/4"W x 2 3/4"H (1.9 cm x 7.0 cm), Star Point: 1 1/4"W x 4 1/2"H (3.2 cm x 11.4 cm)
Finished Size: 36" x 48 1/2" (91.4 cm x 123.2 cm)
Die Board Size: 10 in. x 10 in. (25.4 cm x 25.4 cm)
How to Die Cut Sparkle-Tree Shapes:
Apply fusible web product to the wrong side of the fabric, following manufacturer’s instructions, before cutting for fusible appliqué.
- Diamond: Cut and fuse 4 3/4" x 10 3/4" rectangles. Cut eight diamonds across the width of fabric. One yard of 40" wide fabric cuts 24 diamonds.
- Large Tree Leaf: Cut and fuse 5" x 6 1/4" rectangles. Cut eight large tree leaves across the width of fabric. One yard of 40" wide fabric cuts 40 large tree leaves.
- Small Tree Leaf: Cut and fuse 1 1/4" x 3 1/4" rectangles. Cut 12 small tree leaves across the width of fabric. One yard of 40" wide fabric cuts 336 small tree leaves.
- Star Point: Cut and fuse 1 3/4" x 5" rectangles. Cut eight star points across the width of fabric. One yard of 40" wide fabric cuts 160 star points.
Why Quilters Love the GO! Sparkle-Tree Die:
- No template required. The GO! Sparkle-Tree die includes applique shapes that are typically difficult to cut by hand.
- GO! Sparkle Embroidery Designs CD by Sarah Vedeler Designs coordinates with this GO! die to create stunning embroidery and embroidered applique.
- Quickly and easily cut four of each pre-fused applique shape in one pass thru the cutter (fusible counts as one half layer of fabric).
- Cut Sparkle-Tree out of a variety of fabrics: cotton, batiks, wool, felt, flannel, fleece, Cuddle® fabrics and more!
- A great way to use up scraps.
- Free pattern downloads available to get you started.
- Layer Cake and Fat Quarter-friendly.
AccuQuilt Benefits:
- Cut so much more fabric in less time.
- Get accurate cuts every time -- No slipping rulers or mistakes
- Easiest to use -- Simply place die on cutter, then fabric and cutting mat on top
- Save fabric with Two Tone Foam -- Get more out of your fabric by placing it only over the shape you want to cut.
- Safe to use -- No blades come anywhere near your fingers
Die Tips:
- With some fabrics, after cutting, a thread or two will remain where die blades meet. Snip threads with scissors.
- Blades on some dies are positioned at an angle. Align fabric to edge of shape, not edge of die board.
- Use good quality fabric to reduce fabric stretch.
- It's always a good idea to test cut one shape before cutting many shapes to ensure fabric orientation is correct.